Walk Behind Service & Repair

Expert Service. Transparent Pricing. Worry-Free Results.  
See our pricing guide and schedule an appointment below

See pricing and schedule service

Single Blade 20" to 23"
Seasonal Maintenance
Basic Seasonal Maintenance
$109.95 +Parts
Average Total: $130-$135

Preventative maintenance to keep your machine in good condition.
For machines that do not run well, or do not start, see the repair section below.   
Blade Sharpening/Replacement*
Oil Change
Air filter replacement
Spark plug replacement
General inspection
Drive cable adjustment
Drive belt inspection
Schedule Now

Note: We can do seasonal maintenance on all brands but we only repair Toro and Honda Walk behind mowers.

N

*If needed, blades are usually around $25/ea

Repair

We can handle every repair that your equipment may need. Pricing varies quite a bit based on the repair and parts needed, but common repairs average $150–$300.

Note: We only repair Honda and Toro Walk behind mowers, but we can do seasonal maintenance on most brands.

  • Trip charge: $60
  • Shop rate: $140/hr
  • Minimum appointment charge: $95 — includes the $60 trip charge and up to 15 minutes of labor

At your appointment, the technician will diagnose the problem and provide a rough estimate of the repair cost for you to approve or decline, along with their recommendation on whether the repair makes sense.

Our service trucks are stocked with parts for most common repairs, and we complete the repair during the initial visit whenever possible. Occasionally, diagnosis identifies an uncommon part that we don't normally stock. If a part must be ordered and a return visit is needed to complete the repair, a reduced $45 return trip charge applies.

You will not be charged for an additional trip if we need to return because of an error on our part.

We will never advise you to repair a lost cause, and we will never recommend a repair when the cost isn't justified.

Repairs are billed using flat-rate labor times for common repairs whenever available. Diagnostic, electrical, and non-standard repairs are billed at the posted hourly rate.

Time Master & Other Twin Blade
Seasonal Maintenance
Basic Seasonal Maintenance
$129.95 +Parts
Average total: $155-$165
Blade Sharpening/Replacement*
Oil Change
Air filter replacement
Spark plug replacement
General inspection
Deck/belt cover cleanout
Primary belt & timing belt inspection
Drive belt inspection
Drive cable inspection
Schedule Now

*If needed, blades are usually around $25/ea

Repair

We can handle every repair that your equipment may need. Pricing varies quite a bit based on the repair and parts needed, but common repairs average $150–$300.

  • Trip charge: $60
  • Shop rate: $140/hr
  • Minimum appointment charge: $95 — includes the $60 trip charge and up to 15 minutes of labor

At your appointment, the technician will diagnose the problem and provide a rough estimate of the repair cost for you to approve or decline, along with their recommendation on whether the repair makes sense.

Our service trucks are stocked with parts for most common repairs, and we complete the repair during the initial visit whenever possible. Occasionally, diagnosis identifies an uncommon part that we don't normally stock. If a part must be ordered and a return visit is needed to complete the repair, a reduced $45 return trip charge applies.

You will not be charged for an additional trip if we need to return because of an error on our part.

We will never advise you to repair a lost cause, and we will never recommend a repair when the cost isn't justified.

Repairs are billed using flat-rate labor times for common repairs whenever available. Diagnostic, electrical, and non-standard repairs are billed at the posted hourly rate.

Commercial/40"+
Seasonal Maintenance
Basic Seasonal Maintenance
$189.95 +Parts/Supplies
Average Total: $260-$270
Oil + filter change
Spark plug replacement
Air filter replacement
Blade sharpening/replacement*
Fuel filter replacement
Battery test/replacement*
Tire pressure check/fill
Grease point lubrication
General inspection of belts/driveline, deck, engine operation & general operation
Schedule Now

*Additional cost; Blades are usually around $25/ea, Battery cost varies but is usually around $85; the technician will need your approval before replacing these parts.

Repair

We can handle every repair that your equipment may need. Pricing varies quite a bit based on the repair and parts needed, but common repairs average $150–$300.

  • Trip charge: $60
  • Shop rate: $140/hr
  • Minimum appointment charge: $95 — includes the $60 trip charge and up to 15 minutes of labor

At your appointment, the technician will diagnose the problem and provide a rough estimate of the repair cost for you to approve or decline, along with their recommendation on whether the repair makes sense.

Our service trucks are stocked with parts for most common repairs, and we complete the repair during the initial visit whenever possible. Occasionally, diagnosis identifies an uncommon part that we don't normally stock. If a part must be ordered and a return visit is needed to complete the repair, a reduced $45 return trip charge applies.

You will not be charged for an additional trip if we need to return because of an error on our part.

We will never advise you to repair a lost cause, and we will never recommend a repair when the cost isn't justified.

Repairs are billed using flat-rate labor times for common repairs whenever available. Diagnostic, electrical, and non-standard repairs are billed at the posted hourly rate.

Multi-Machine Discount

Bundle & Save 10%

Got more than one piece of equipment? Schedule seasonal maintenance on multiple machines together and automatically save 10% on every service, no coupons, no catch.

A note about the general inspection

If any repairs are found and recommended that are not included in the service, they will be listed on the invoice and we will discuss them with you. For most smaller repairs, the technician may be able to do them the same day. For larger repairs, we will email you an estimate with a deposit for you to approve or deny. Once the estimate is approved and the deposit is paid, we will get you scheduled for the repair.

For more specific estimates, please text 651-661-7475 with your model number